sobamy wrote:jeuda wrote:It worked! Thanks a million.
You are welcomed. Glad to be of help. Next time, test it on a "dummy" device but not on your valuable set.
BTW, which "antidote" did you use? The hard re-set or the "cure"?
Dummy device? I only 3 sets as shown in my signature.
Used the hard re-set then when performing the touch screen calibration. I connected the uSB cable. Drive showed up on PC. Copied the Gupdate.GCD from my other 1300 set to this 1350. It worked for a while (that night). This morning try again, it start rebooting again but not stuck at software uploading. I also puzzled now.